Omron PRT1-COM Operation Manual page 98

Transistor Output Units
Dimensions
Connector Cables
When a Transistor Output Unit (connector) is to be connected to an OMRON I/O
Block or a Connector--Terminal Block Conversion Unit, use the cables (sold
separately) listed in the following table.
Manufacturer
OMRON
XW2Z-jjjA
G79-jjjC
Note V terminals and G terminals are internally connected. When the I/O power is
being supplied, the power can be supplied to the output devices from the V and
G connectors. Current supplied in this way, however, must be less than 2 A. If,
instead of using the V and G connectors, the power supply is wired to the
terminal block as shown in the following diagram, the current supplied must be
less than 2.5 A.
Note The vertical center of the Unit is 4.9 mm lower than the center of the DIN track.
The Unit therefore extends downward 41.4 mm (including the mounting hook)
from the DIN track center.
Model number
Connector--Terminal Block Conversion Unit
XW2B-20G4
XW2B-20G5
I/O Block
G7TC-OC16-1
G70D-SOC16-1
G70D-FOM16-1
G70A-ZOC16-4
M7F
Output Unit
I/O Block (example)
Approx. 59
Section
Corresponding device
Load
(Unit: mm)
6-3
87