Connection To A Pc By The Nt Link; Compatible Pcs; Connecting The Nt11S - Omron NT11S Operation Manual

Connection to a PC by the NT Link

2-6

Connection to a PC by the NT Link

2-6-1

Compatible PCs

2-6-2

Connecting the NT11S

Connect the NT 11S to an OMRON PC by the NT link method.
To connect the NT11S to a PC by the NT link method, the NT11S memory switch
for "host communication" must be set for the NT link. For the "host communication"
setting, refer to "Selecting the Host Communication Method" (page 58)
Some models and series of OMRON PCs have the host link function built in.
Check the model and series of the PC against the type of host link unit before
marking the connections.
The compatible PCs are listed in the table below.
PC Series
C series C series
Refer to the illustrations below to select the appropriate cable for the unit connec-
tors and connect the NT11S to the PC.
To make a connector cable, refer to Appendix D Method for Making the Cable for
Connection to the PC (page 146).
Caution
S After connecting a communication cable, always secure it with the screws.
Otherwise the cable may disconnect, causing operation to fail.
S The cable's tensile load is 30 N. Do not subject it to loads greater than this.
Otherwise a discontinuity may occur, causing operation to fail.
Use a connector cable with a 9-pin connector on both ends to connect the NT11S
to a PC with a 9-pin connector.
Host I/F connector
(RS-232C 9-pin type)
9-pin connector
CQM1-CPU41-E
CQM1-CPU42-E
CQM1-CPU43-E
CQM1-CPU44-E
C200HS-CPU21-E
C200HS-CPU23-E
C200HS-CPU31-E
C200HS-CPU33-E
NT11S
RS-232C connector cable
CPU Unit
CQM1
C200HS
CPU unit
Section 2-6
Connectable to
C200HS,
CQM1
9-pin connector
37