System Switch 07 - Not Used; System Switch 08 - Not Used - Ricoh C2000 Service Manual

System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 [SP No. 1-101-010]
No FUNCTION
0 Not used
Inclusion of communications on the
Journal when no image data was
1
exchanged.
0: Disabled 1: Enabled
Automatic error report printout
2
0: Disabled 1: Enabled
Printing of the error code on the
error report
3
0: No 1: Yes
4 Not used
Power failure report
5
0: Disabled 1: Enabled
Conditions for printing the protocol
dump list
6 0: Print for all communications
1: Print only when there is a
communication error
Priority given to various types of
remote terminal ID when printing
reports
7 0: RTI > CSI > Dial label > Tel.
Number
1: Dial label > Tel. number > RTI >
CSI
COMMENTS
Do not change these settings.
0: Communications that reached phase C (message tx/rx)
of the T.30 protocol are listed on the Journal.
1: Communications that reached phase A (call setup) of T.
30 protocol are listed on the Journal. This will include
telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
1: Error codes are printed on the error reports.
Do not change this setting.
1: A power failure report will be automatically printed after
the power is switched on if a fax message disappeared from
the memory when the power was turned off last.
This switch becomes effective only when system switch 00
bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol dump
list only for communications with errors.
This bit determines which set of priorities the machine uses
when listing remote terminal names on reports.
Dial Label: The name stored, by the user, for the Quick/
Speed Dial number.
Bit Switches
4
53