Fax Switches - Ricoh C2000 Service Manual

I-Fax Switches
I-fax Switch 00 [SP No. 1-102-001]
FUNCTION
No
Original Width of TX
Attachment File
0 A4
1 B4
2 A3
3-6 Reserved
7 Not used
I-fax Switch 01 [SP No. 1-102-002]
FUNCTION
No
Original Line Resolution of TX
Attachment File
0 200x100 Standard
1 200x200 Detail
2 200x400 Fine
3 300 x 300 Reserve
4 400 x 400 Super Fine
5 600 x 600 Reserve
6 Reserve
COMMENTS
This setting sets the maximum size of the original that the
destination can receive. (Bits 3~7 are reserved for future use or
not used.)
0: Off (not selected), 1: On (selected)
If more than one of these three bits is set to "1", the larger size
has priority. For example, if both Bit 2 and Bit 1 are set to "1"
then the maximum size is "A3" (Bit 2).
When mail is sent, there is no negotiation with the receiving
machine at the destination, so the sending machine cannot make
a selection for the receiving capabilities (original width setting) of
the receiving machine. The original width selected with this switch
is used as the RX machine's original width setting, and the original
is reduced to this size before sending. The default is A4.
If the width selected with this switch is higher than the receiving
machine can accept, the machine detects this and this causes an
error.
These settings set the maximum resolution of the original that
the destination can receive.
0: Not selected
1: Selected
If more than one of these three bits is set to "1", the higher
resolution has priority. For example, if both Bit 0 and Bit 2
are set to "1" then the resolution is set for "Bit 2 200 x 400.
COMMENTS
Bit Switches
4
61