Ricoh C2000 Service Manual page 19

3. Troubleshooting
Code
3
The other terminal did not reply
0-06
to DCS
No post-message response
0-07 from the other end after a page
was sent
The other end sent RTN or PIN
0-08 after receiving a page, because
there were too many errors
18
Meaning
Cross reference
See error code 0-04.
• Check the line connection.
• Try adjusting the tx level and/or cable equalizer
• Replace the NCU or FCU.
• The other end may be defective or incompatible; try
• Check for line problems.
Cross reference
See error code 0-04.
• Check the line connection.
• Replace the NCU or FCU.
• The other end may have jammed or run out of paper.
• The other end user may have disconnected the call.
• Check for a bad line.
• The other end may be defective; try sending to another
• Check the line connection.
• Replace the NCU or FCU.
• The other end may have jammed, or run out of paper
• Try adjusting the tx level and/or cable equalizer
• The other end may have a defective modem/NCU/
• Check for line problems and noise.
Cross reference
• Tx level - NCU Parameter 01 (PSTN)
• Cable equalizer - G3 Switch 07 (PSTN)
• Dedicated Tx parameters in Service Program Mode
Suggested Cause/Action
settings.
sending to another machine.
machine.
or memory space.
settings.
FCU; try sending to another machine.