Wiring - Heat & Glo ESCAPE-30LP-IFT Installation Manual

B. Wiring Requirements - IntelliFire™ Touch
Ignition System Wiring
• Wire the appliance junction box to 110-120 VAC for
proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• Refer to Figure 8.2, IntelliFire
Diagram.
• This appliance is equipped with an IntelliFire control valve
which operates on a 6 volt/1.5 AMP system.
• Plug the 6 volt transformer plug into the supplied cord
assembly to supply power to the unit OR install 4 AA cell
batteries (not included) into the battery pack before use.
IFT-RC400
REMOTE
CONTROL
IFT-RC150
WIRELESS
WALL SWITCH
(OPTIONAL)
2166-302 (NG)
2166-303 (LP)
Figure 8.2 IntelliFire™ Touch Wiring Diagram
Heat & Glo • ESCAPE-35-IFT, ESCAPE-30-IFT Installation Manual • 2550-980 Rev. B • 6/18
20
Touch (IFT) Wiring
TM
FLAME
IGNITER
SENSE
2550-013 (NG)
2550-014 (LP)
S I
2326-130
RF MODULE
2326-120
2550-753
6 PIN
NOTICE: Batteries should only be used as a power source
in the event of an emergency power outage. Batteries
should not be used as a primary long-term power source.
Battery polarity must be correct when installing batteries.
When using batteries as a power source, the 6-volt
transformer must be unplugged from the receptacle.
Do not store batteries in the battery pack when the
appliance is powered by the 6 volt transformer connected
to permanent electrical service.
Battery Pack
Battery pack is not factory installed in appliances. See
appliance manual bag for battery pack. Battery pack
should only be installed during power outages.
TO CORD ASSEMBLY 110-120 VAC
2326-131
2206-299
MODULE
6V TRANSFORMER
RESET
PLUG
SWITCH
2550-135
TO CORD
ASSMBLY
110-120 VAC
2326-152
2326-150
BLK
RED
2550-301
BATTERY PACK
RED
BLK
FAN 110-120 VAC
GFK-210-C
2326-134
HALOGEN BULBS (X 2)
2201-150
LIGHT WIRE
ASSEMBLY
2532-017