Heat & Glo ESCAPE-30LP-IFT Installation Manual page 30

GLASS ROCK
Figure 7. Glass Rock in Place
GLASS ROCK (2201-853): Once Log #3 and Log #4 are installed, fill each light tray with the glass rock. See Figure 7.
WARNING! Risk of Explosion! DO NOT place glass rock on the burner surface. DO NOT place glass rock directly over
burner ports. Improperly placed glass rock interferes with proper burner operation.
LOG #5 (SRV2201-703): SEE FIGURE 2 FOR ADDITIONAL REFERENCES. Place the thick end of Log #5 on the flat
spot of Log #1. Locate the groove on the thin end of the log. Mate the groove with the grate bar as shown above. Swing
the front end of the log to the right, until it contacts the second grate tine from the right.
Figure 9. Place Log #6
Log #6 (SRV2201-706): See Figures 2 and 4 for additional references. Place the thick end of the log on the flat spot of Log
#2. Place the thin end of the Log #6 on the flat spot of Log #5 as shown in Figure 8.
Heat & Glo • ESCAPE-35-IFT, ESCAPE-30-IFT Installation Manual • 2550-980 Rev. B • 6/18
30
6
PLACE LOG ON FLAT SPOT
5
LOG TOUCHES GRATE TINE
GROOVE MATES
WITH GRATE BAR
Figure 8. Place Log #5
FLAT SPOT
FOR LOG #6
2201-935G