Invacare Roze User Manual page 52

Invacare® Roze™
52
1. Unplug the electric actuator A from the control box on
the mast assembly. Thread the actuator lead through
the actuator lead routing hole B in the mast assembly.
2. Remove the hardware that secures the top of the
electric actuator to the lift arm actuator mounting
bracket C.
a. Remove the rubber caps D from the nut E and
screw F that attach the electric actuator to the lift
arm actuator mounting bracket.
b. Remove the screw F, washer G, bearing H, nylon
washer I, actuator cap J, bushing K, flat washer
L and nut E.
The actuator cap will become loose when the
attaching hardware is removed. Inspect the
actuator cap for damage. Replace the actuator
cap if damage is found.
3. Remove the hardware that secures the bottom of
the electric actuator to the mast assembly actuator
mounting bracket M.
a. Remove the rubber caps D from the nut E and
screw F that attach the electric actuator to the mast
assembly actuator mounting bracket.
b. Remove the screw F, washer G, bearing H, nylon
washer I, bushing K, bearing H, washer G, flat
washer L and nut E.
4. Reverse STEPS 1-3 to replace the electric actuator.
CAUTION!
Improper assembly may cause injury or damage.
– DO NOT overtighten the mounting hardware.
This will damage the mounting bracket.
1195052-B