System Routing Table; Bandwidth Control - TP-Link TL-WR902AC User Manual

Chapter 8
• Interface - It is empty by default. Please select a connection from the drop-
down list if the Gateway is left empty or is not on the same network segment as
LAN/WAN interface.
3. Select Enabled or
4. Click Save.
You can also do the following operations to modify the current settings.
• Click Delete Selected
• Click Enable Selected
• Click Disable Selected

8. 11. 2. System Routing Table

1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Advanced Routing
entries in use.
• Destination Network
to which the static route is assigned.
• Subnet Mask - The Subnet Mask determines which portion of an IP address is the
network portion, and which portion is the host portion.
• Gateway - This is the IP address of the gateway device that allows for contact between
the Router and the network or host.
• Interface - This interface tells you whether the Destination IP Address is on the LAN &
WLAN (internal wired and wireless networks), or the WAN (Internet).
• Click Refresh to refresh the data displayed.

8. 12. Bandwidth Control

1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Bandwidth Control.
3. Configure the bandwidth as needed and click Save.
Disabled for this entry on the
to delete selected entries.
to enable selected entries.
to disable selected entries.
> System Routing
- The Destination Network is the address of the network or host
Configure the Router in Hotspot Router Mode
Status drop-down list.
Table, and you can view all the valid route
194