System Routing Table; Bandwidth Control; Control Settings - TP-Link Archer C50 User Manual

Chapter 4
• Gateway - This is the IP address of the default gateway device that allows the
contact between the router and the network or host.
3. Select Enabled or
4. Click Save.
You can also do the following operations to modify the current settings.
• Click Delete to delete the entry.
• Click Enable All to enable all the entries.
• Click Disable All to disable all the entries.
• Click Delete All to delete all the entries.
• Click Previous to view the information on the previous screen and
information on the next screen.

4. 13. 2. System Routing Table

1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced Routing
entries in use.
• Destination Network
to which the static route is assigned.
• Subnet Mask - The Subnet Mask determines which portion of an IP address is the
network portion, and which portion is the host portion.
• Gateway - This is the IP address of the gateway device that allows for contact between
the Router and the network or host.
• Interface - This interface tells you whether the Destination IP Address is on the LAN &
WLAN (internal wired and wireless networks), or the WAN (Internet).
• Click Refresh to refresh the data displayed.

4. 14. Bandwidth Control

4. 14. 1. Control Settings

1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Bandwidth Control.
Disabled for this entry on the
> System Routing
- The Destination Network is the address of the network or host
Configure the Router in Wireless Router Mode
Status drop-down list.
Table, and you can view all the valid route
Next to view the
47