Table of Contents
Advertisement
INSTALLATION AND SETUP
2.2
Installing The Lens
A variety of lenses are available to accommodate different throw distances and specific types of
installations. See page 2-10 for details. To change/install a lens, follow the steps below.
NOTES: 1) You will need a 9/64"(3mm or 3.5mm) hex socket ball driver (supplied with projec-
tor) or allen wrench for this procedure. 2) "Top" or "bottom" references assume a non-inverted
projector, as illustrated. 3) If you are installing a lens, first make sure its Lens Adapter is present
on either the lens or projector. Such an adapter/flange secures to the projector in the same man-
ner as the flange described below, but accommodates a screw-mount lens.
STEP 1
Turn off the projector, cool, and unplug.
Before removing or installing a lens, turn off the
projector and allow it to cool for five minutes before
unplugging. Make sure that the lens cap is on.
STEP 2
Loosen the 3 lens mount screws
IF FIXED LENS: Use the hex socket ball driver
provided with the projector to loosen the 3 lens mount
screws that secure the lens flange to the mount-loosen
these screws only, do not remove.
!
WARNING
Unplug the projector.
Install the lens cap.
2-2
Install Lens Cap
Loosen 3 screws
- FIXED LENS -
Advertisement
Table of Contents
