Runco Video Xtreme VX-4c Owner's Operating Manual page 51

OPERATION
IR and SERIAL SETUP MENU
Use the checkboxes and pull-down lists in the IR and
Serial Setup menu to alter the meth ods or types of
communication to and from the projector. Changes
made to the IR and Serial Setup menu will be saved
when you exit the menu.
Baud Rate
NOTE: 1) The baud rate setting does not affect the switcher port, which is always 9600 baud.
Display M. Bank List
Enter a checkmark if you want to see a scrollable channel list whenever you press
from your presentation (note that each channel to be included in the list must also be
tagged in the "In Menu" checkbox in the Memory Banks menu). This option also enables
on-screen feedback when using the
input dialog box while switching channels and sources during a presentation, do not enter
a checkmark.
NOTE: The Bank List and input dialog box cannot be hidden when a menu is dis
played.
Show Adjust Bar
Enter a checkmark to superimpose a small sidebar over the current image whenever an
adjustable parameter is selected directly with the keypad. If "Show Adjust Bar" is
unchecked, these slidebars can still be accessed, but will be hidden during adjustment.
Show Message
Choose in what way you want to be notified of errors detected in either the incoming
signal or projector. Select "Screen" or "All" to see a brief on-screen message or select
"RS232" to be see messages via RS232 and RS422 serial communication only. To dis-
able error message display, select "Off."
The baud rate setting determines the speed of communications to and
1200
from the projector. By default, the projector baud rate is set to 9600.
2400
Setting the correct speed is important when you are controlling the
projector with an external device or another projector via an RS-232 or
9600
RS-422 port. You must set the projector baud rate at these ports to
19200
match the baud rate of the controlling device. If you are unsure about
38400
what baud rate to choose, refer to the documentation for the control-
57600 ling device.
115200
key. If you prefer to hide the channel list and
Input
3-25
IR and Serial Setup
Installation Menu
Chan