Runco Video Xtreme VX-4c Owner's Operating Manual page 43

OPERATION
MEMORY BANK EDIT - STEP 1
Press
move the highlight to the Memory Bank Setup option and press
menu will appear.
MEMORY BANK EDIT - STEP 2
To edit parameters shown in the Memory Bank Setup menu, select the relevant channel and press
Enter
MEMORY BANK - STEP 3
If desired, edit the following channel setups in the Memory Bank menu:
MEMORY LABEL: An alpha-numeric label can be defined and/or changed here. Memory Bank
names can be up to 12 characters in length.
BANK: A bank number from 01 to 99 can be changed here. NOTE: If you enter a bank number that
already exists, a dialog message appears indicating that this number is already in use-assign a dif
ferent bank number.
SWITCHER: "0" represents the projector itself. This will likely always be the case for the
VX-4c/VX-6c.
SLOT: 1 (
LIST: If checked (default, except for automatically defined banks with unchanged parameters), this
defined bank will then appear in the list available when
bank must be accessed via
display of the bank list is an option that must be set in the OSD Settings Menu.
AUTO SYNC: If checked, (default), the projector can automatically locate this bank when an
incoming input signal matches. If not checked, the projector can locate the selected bank only
when it is directly selected via on the keypad-and a change in input signal will not result in a bank
change.
PROTECT: If checked, all of the image settings for this bank will be disabled. If unchecked
(default), all available settings can be adjusted as desired.
to display the main menu. To display the Memory Bank Setup menu, press
Menu
. The Memory Banks menu will appear similar to the sample shown below.
Memory Label
Switcher
Auto Sync
Protect
Last Bank
Next Bank
Memory Banks Menu (SAMPLE)
), 2 (
Input2
Input1
Memory Banks
Sync Type
Bank 3
H Freq -15.73kHz
0
V Freq -59.94Hz
Slot 1 Interlaced
List
), 3 ( ), or 4 (
Input3
Input4
on the keypad or via the Auto Source function. NOTE: On-screen
Chan
3-17
. The Memory Bank Setup
Enter
Seperate H,V
Yes
) for projector inputs.
key is pressed. If unchecked, the
Chan
, or
3