Table of Contents
Advertisement
Color
Color
Press
to adjust the color saturation level, i.e. the amount of color in a video image. Lower
Color
settings produce less saturated colors - a setting of "0" produces a black and white image, for
example. If the color level is too high, colors will be overpowering and unrealistic. Use
until the
input.
Tint
Tint
Press
to adjust the red/green color hue for true color reproduction of NTSC video signals.
Tint
For best results, adjust tint while displaying a proper test pattern - otherwise, it is recommended
that tint remain at its default setting. Use
is not used when an RGB source is input.
Detail
Detail
Press
to adjust the sharpness of a video image (it is of limited use for non-video). Use
Detail
and
above 3 will also introduce a certain degree of noise in the image. Set below 3 to filter the signal
and remove noise from a noisy source. This is not used when an RGB source is input.
Contrast
Cont
Press
Cont
Use
and
remain bright but not distorted or tinted (i.e., "crushed").
Brightness
Bright
Press
to increase or decrease the amount of perceived light in the image so that black just
Bright
changes to very dark gray. Use
the Image (Scaling Parameters subsection). Avoid "crushing", or distorted blacks and/or whites.
Volume
Vol
Press
to control the audio level. Use
Vol
Pixel
Pixel
Press
to access the pixel tracking and pixel phase double slidebar. Adjust pixel tracking first:
Pixel
use
and
consistency of the image. For proper phase, use
so that any shimmer disappears and the image is stable throughout. See 3.6, Adjusting the Image
(H & V Scaling subsections) for a complete explanation of tracking and phase.
+
Mute*
+
Mute*
+
OSD*
+
OSD*
desired color saturation level is displayed. This is not used when an RGB source is
until you reach the desired level of detail, keeping in mind that any level of detail
to increase or decrease the difference between light and dark areas of your image.
until you reach the desired level of contrast, making sure that the whites
to increase or decrease the frequency of the pixel sampling clock to correct
turn the audio and menu display on
=
ON
turn the audio and menu display off
=
OFF
turn the menu system on
=
ON
turn the menu system off
=
OFF
and
until the desired tint is displayed. This
and
until you reach the desired level. See 3.6, Adjusting
and
and
ON
OFF
3-6
OPERATION
until you reach the desired volume.
to increase or decrease pixel phase
and
Advertisement
Table of Contents
