Ricoh SP C360 series User Manual page 136

8. Adding Paper and Toner
can print only in black and white after any of the cyan, magenta, or yellow toner runs out. Keep the
empty print cartridge attached until you replace it with a new print cartridge.
• Fault may occur if you use toner other than the recommended type.
• When adding toner, do not turn off the main power. If you do, settings will be lost.
• Store toner where it will not be exposed to direct sunlight, temperatures above 35°C (95°F), or
high humidity.
• Store toner horizontally.
• Do not shake the toner cartridge with its mouth down after removing it. Residual toner may scatter.
• Do not repeatedly install and remove toner cartridges. This will result in toner leakage.
• Do not touch the shutter on the bottom side of the print cartridge.
Follow the instruction on the screen regarding how to replace a toner cartridge.
• If "Toner Cartridge is almost empty." appears on the display, the toner has almost run out. Have a
replacement toner cartridge at hand.
• If appears when there is a lot of toner, hold the cartridge with the opening upward, shake it
well, and then reinstall it.
• When "No toner." appears on the display, you can check the name of the required toner and the
replacement procedure using the [ Add Toner] screen. To display the [ Add Toner] screen, press
[Check Status], and then press [Check] in the [Mach. Status] area in the [Mach./Applic. Stat] tab.
134
DSE264