Basic Operation (Factory Setting) - Mitsubishi Electric FR-D720-0.2K-G Instruction Manual

4.1.2

Basic operation (factory setting)

Operation mode switchover
At powering ON (External operation mode)
PU operation mode
(Rotation speed monitor)
Parameter setting mode
(Refer to page 53.)
parameter setting
Value change
Keep pressing
the setting dial
Output current monitor
Value change
Parameter clear
Automatic PM parameter
[Operation for displaying fault history]
The past eight faults can be displayed.
(The latest fault is ended by ".".)
When no fault history exists,
While a fault is displayed:
The display shifts as follows by pressing
Output current Output voltage
(After Energization time, it goes back to a fault display.)
Pressing the setting dial shows the fault history number.
PU Jog operation mode
(After 1s)
PM motor Set speed
contorl is displayed
STOP
All parameter
clear
initialization
(Refer to page 249.)
is displayed.
: Rotation speed at the fault
Energization time.
Operation panel
(Example)
and the speed appear alternately.
The speed setting has been
written and completed!!
Output voltage monitor
Display the
present setting
(Example)
Parameter and a setting value
appear alternately.
Parameter write is completed!!
Fault history clear
Initial value
change list
4
51