Setting The Speed By The Operation Panel - Mitsubishi Electric FR-D720-0.2K-G Instruction Manual

Selection of operation mode and operation location

4.16.2 Setting the speed by the operation panel

POINT
 Use the operation panel to give a start command and a speed command. (PU operation)
Operation
Operate at 900r/min.
example
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Change the Pr. 79 setting to "1".
(Refer to page 52 for change of the setting.)
3.
Turn to show the speed you want to set.
The speed blinks for about 5s.
4.
While the value is blinking, press
the speed.
(If is not pressed, the indication of the
value goes back to "
of blinking. In that case, go back to "operation
step 3" and set the speed again.)
After about 3s of blinking, the indication of the
value goes back to "
5.
Start  acceleration  constant speed
Press to start operation.
The speed value on the indication increases in
Pr. 7 Acceleration time, and "
appears.
6.
To change the set speed, perform the operation in above steps 3 and 4. (Starting from the previously set speed.)
7.
Deceleration  stop
Press to stop.
The speed value on the indication decreases in
Pr. 8 Deceleration time, and the motor stops
rotating with "
172
to set
" (0r/min) after about 5s
" (monitor display).
" (900r/min)
" (0r/min) displayed.
Operation panel
PU indicator is lit.
Blink...speed setting complete!!
The monitor display appears after 3s.
Display
Blinks for about 5s
Stop