Configuration Tool - ABB UMC100.3 Manual

S Y S T E M O V E R V I E W

Configuration Tool

Asset Vision Basic is the tool to configure the UMC100.3 via a laptop.
Asset Vision Basic is jointly used between ABB Instrumentation and ABB Control Products. Therefore it enables a wide range of
ABB products to be configured such as motor controllers, soft starters, flow meters and many more. It is based on the FDT/DTM
standard which also enables the configuration of third-party products that are connected at the same bus segment. You can
parameterise the UMC100.3 both online and offline. In offline mode the configuration can be fully prepared and then later on
loaded into the device(s). If a connection to a device exists, online-monitoring of all measured values, maintenance counters etc. is
possible.

Configuration
window
of the
motor protection
functions

Status Window
—
UMC100.3 configuration tool Asset Vision Basic with the motor protection
configuration window 3. In 1 the toolbar of the tool is shown. 2 provides a
network view with all the devices accessible on the PROFIBUS DP line. 4 contains a
window to display messages and buttons to quit or adopt the parameter changes.
The diagram above shows the configuration tool which allows intuitive configuration of all UMC100.3 functions.
In this example the window to configure the motor protection parameters is shown. In similar windows all other parameters can be
configured. Other views enable the monitoring of the diagnosis information, the visualisation of bus monitoring, command data
and much more.
Toolbar & Menus


Tree view of
all devices on the
bus line
15