Top Cover Assembly - NEC Versa TXi Series Service Manual

Top Cover Assembly

Remove the top cover assembly as follows.
Turn the notebook over.
1.
2. Locate and remove the four front cover screws and the seven top cover and LCD panel
screws from the bottom of the notebook. Also remove the LCD panel screw at the back of
the notebook.
Note
Several different types and lengths of screws are used. As you remove the screws,
note the screw type, length, and position. Use care to ensure that all screws are returned to their
original positions.
A – Front Cover Screws (4)
B – Top Cover and LCD Panel Screws (7)
3. Grasp the top and bottom of the notebook to hold it together, turn it over, and open the LCD
panel as much as possible.
Remove the primary battery, keyboard, front cover and VersaGlide assembly, hard disk
4.
drive, and PC card assembly from the notebook.
Unplug the following top cover cables from the main board:
5.
control panel cable from P10 on the main board
n
left and right speaker cables from P22 on the main board.
n
3-14 Disassembly and Reassembly
Removing the bottom screws
C – LCD Panel Screw (on rear of notebook)