Usb Board - NEC Versa TXi Series Service Manual

USB Board

Remove the USB board as follows.
Remove the primary battery, keyboard, front cover and VersaGlide assembly, and hard disk
1.
drive from the notebook.
Locate the USB board on the right side of the notebook, under the location of the hard disk
2.
drive.
Locate and remove the two screws fastening the USB board to the notebook.
3.
Locate and remove the standoff post screw from the USB board.
4.
Remove the screw from the top of the standoff post.
n
Insert the end of a small flat blade screwdriver through the hole where the screw was
n
and into the slot on the top of the standoff post. Use care to avoid damaging the
standoff's internal threads.
Loosen the standoff post.
n
Carefully unplug USB board connector P56 from connector P52 on the sound board under
5.
the USB board.
6. Remove the USB board and standoff post from the notebook.
Removing the USB board
A – USB Board
B – Screws (2)
C – Standoff Screw and Post
D – Connector P56 (underside of USB board)
Disassembly and Reassembly 3-13