Primary Battery - NEC Versa TXi Series Service Manual

n
Do not disassemble the system into parts that are smaller than those specified in the
procedure.
n
Several different type of screws are used to fasten various parts in the system. As you
disassemble the system, note the screw type, length, and position. Use care to ensure that all
screws are returned to their original positions.
n
Label all removed connectors. Note where the connector goes and in what position it was
installed.

Primary Battery

Remove the primary battery as follows.
Note
Only use batteries that were specifically designed for use in the Versa TXi notebook.
Installing another manufacturer's battery, or using a combination of very old and new batteries
can deteriorate battery and equipment performance.
Turn off system power.
1.
Close the LCD panel and turn the system over.
2.
3. Slide the battery release latch toward the side of the system and hold firmly.
4. Continue to hold the battery release latch as you pull the battery out of the system.
Locating the battery release latch
A – Primary Battery B – Battery Release Latch
Disassembly and Reassembly 3-3