Select Memory Scan - Icom IC-7100 Instruction Manual

Previous view
12
SCAN OPERATION
Memory scan (Memory mode) (Continued)
D

Select Memory scan

The Select Memory scan searches for signals through
Memory channels specifi ed as "" (Select).
NOTE: For a Select Memory scan to start, two or
more Memory channels must be designated as Se-
lect Memory channels. (See below)
q q through e as described on the page
Follow steps
??-?? to display the "SCAN" screen.
w D) for 1 second, and then touch
Touch [MEMO](
"SEL-MEMO" to start the Select Memory scan.
• The MHz and kHz decimal points, and "SEL–MEMO
SCAN" blink while scanning.
• If "Up/Down" is selected as the "MAIN DIAL (SCAN)" op-
tion in the Scan Set mode, rotating the Dial changes the
scanning direction. (p. ??-??)
e D) to cancel the scan.
Push [MEMO](
L eft D isplay
C enter
While Select Memory scanning
12-12
The L, R, C or D in the
R ight
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
Touch [MEMO]
for 1 second.
Touch
"SEL-MEMO."
Appears