Inserting The Sd Card; Formatting The Sd Card - Icom IC-7100 Instruction Manual

Previous view
13
USING AN SD CARD

Inserting the SD card

q
Turn OFF the transceiver.
w
Insert the card into the slot until it locks in place, and
makes a 'click' sound.
• " " appears when the SD card is inserted.
• " " and " " alternately blink while accessing the SD
card.
NOTE: Before inserting, be sure to check the card
direction.
If the card is forcibly or inversely inserted, it will dam-
age the card and/or the slot.
D

Formatting the SD card

• If you use a brand new SD card, format it, by doing
the following steps.
• Formatting a card erases all its data. Before for-
matting any programmed card, make a backup fi le
onto your PC.
q
Turn OFF the transceiver, and then insert the card
into the slot.
w
Turn ON the transceiver.
• " " appears when the SD card is inserted.
e
Push (C) to enter the Set mode.
SET
r
Touch the "SD Card" Set mode.
• If the specifi ed item is not displayed, touch [∫] or [√](D)
one or more times to select the page.
t
Touch the "Format" item.
• The confi rmation screen "Format OK?" appears.
y D).
Touch [YES](
• The formatting starts and the display shows the format-
ting progress.
• After formatting ends, the display automatically returns to
the screen displayed before touching [YES](D).
Front
panel
SD card
Terminals
facing down
L eft D isplay
C enter
w
●
13-4
Cut corner side
Appears
The L, R, C or D in the
R ight
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
q
q