Roland SuperNATURAL ARX-01 Owner's Manual page 63

44: REVERSE DELAY
Adds the reverse of the input sound as a delay.
fig.MFX44
L in
D1
Rev. Delay
Feedback 1
Feedback 4
R in
Parameter Value
Threshold 0–127
Delay 1–4 0-2000 ms,
(Delay 1 #1) note
Feedback 1 #2
-98– +98 %
Feedback 4
HF Damp 1
200–8000 Hz,
BYPASS
HF Damp 4
Pan 1–3
L64–63R
(Pan 1 #3)
Level 1–3 0–127
D100:0W–
Balance #4
D0:100W
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
2-Band
EQ
1
D2
Delay
2
D3
D4
3
2-Band
EQ
Description
Volume level at which the reverse delay
begins
Adjusts the time until Delays 1–4 are
heard.
Adjusts the amount of the delay sound
that's fed back into the effect. Negative (-
) settings invert the phase.
Adjusts the frequency above which sound
fed back to the effect is filtered out. If you
do not want to filter out any high frequen-
cies, set this parameter to BYPASS.
Stereo location of Delays 1–3 sound
Output level of Delays 1–3 sound
Volume balance between the direct
sound (D) and the effect sound (W)
Gain of the low frequency range
Gain of the high frequency range
Output level
45: SHUFFLE DELAY
Adds a shuffle to the delay sound, giving the sound a bouncy delay effect
with a swing feel.
fig.MFX45
L out
L in
Feedback
Delay
R out
R in
Parameter
Delay #1 0–4000 ms, note
Shuffle Rate #2 0–100 %
Pan A/B L64–63R
A100:0B–
Level Balance
A0:100B
Feedback #3 -98– +98 %
Acceleration 0–15
200–8000
HF Damp
Hz, BYPASS
Delay A
A
B
Delay B
Value Description
Adjusts the time until the delay sound is
heard.
Adjusts the ratio (as a percentage) of the
time that elapses before Delay B sounds
relative to the time that elapses before the
Delay A sounds.
When set to 100%, the delay times are
the same.
Stereo location of Delay A/B
Volume balance between Delay A and
Delay B
Adjusts the amount of the delay that's fed
back into the effect. Negative (-) settings
invert the phase.
Adjusts the time over which the Delay
Time changes from the current setting to
its specified new setting.
Adjusts the frequency above which sound
fed back to the effect is filtered out. If you
don't want to filter out any high frequen-
cies, set this parameter to BYPASS.
2-Band
L out
EQ
2-Band
R out
EQ
63