Roland SuperNATURAL ARX-01 Owner's Manual page 51

27: LIMITER
Compresses signals that exceed a specified volume level, preventing
distortion from occurring.
fig.MFX27
L in
Limiter
R in
Limiter
Parameter Value
Release #1 0–127
Threshold #2 0–127
1.5:1, 2:1, 4:1,
Ratio #3
100:1
Post Gain #4 0–18 dB
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
L out
2-Band EQ
R out
2-Band EQ
Description
Adjusts the time after the signal volume
falls below the Threshold Level until com-
pression is no longer applied.
Adjusts the volume at which compression
begins
Compression ratio
Adjusts the output gain.
Gain of the low frequency range
Gain of the high frequency range
Output level
28: SLICER
By applying successive cuts to the sound, this effect turns a conventional
sound into a sound that appears to be played as a backing phrase. This is
especially effective when applied to sustain-type sounds.
fig.MFX28
L in
Slicer
R in
Slicer
Parameter Value
0.05–
Rate #1
10.00 Hz, note
Attack #2 0–127
Input Sync Sw OFF, ON
Input Sync Thresh-
0–127
old
LEGATO,
Mode
SLASH
L out
R out
Description
Rate at which the 16-step sequence will
cycle
Speed at which the level changes be-
tween steps
Specifies whether an input note will
cause the sequence to resume from the
first step of the sequence (ON) or not
(OFF)
Volume at which an input note will be de-
tected
Sets the manner in which the volume
changes as one step progresses to the
next.
LEGATO: The change in volume from one
step's level to the next remains unaltered.
If the level of a following step is the same
as the one preceding it, there is no
change in volume.
SLASH: The level is momentarily set to 0
before progressing to the level of the next
step. This change in volume occurs even if
the level of the following step is the same
as the preceding step.
51