Roland SuperNATURAL ARX-01 Owner's Manual page 56

Parameter
Signal Distortion 0–127
Frequency Range
0–127
#1
Disc Type #2 LP, EP, SP
Scratch Noise Lev-
0–127
el
Dust Noise Level 0–127
Hiss Noise Level 0–127
Total Noise Level
0–127
#3
Wow 0–127
Flutter 0–127
Random 0–127
Total Wow/Flutter
0–127
#4
D100:0W–
Balance
D0:100W
Level 0–127
56
Value Description
Depth of distortion
Frequency response of the playback sys-
tem
Decreasing this value will produce the im-
pression of an old system with a poor fre-
quency response.
Rotational speed of the turntable
This will affect the frequency of the scratch
noise.
Amount of noise due to scratches on the
record
Volume of noise due to dust on the record
Volume of continuous "hiss"
Volume of overall noise
Depth of long-cycle rotational irregularity
Depth of short-cycle rotational irregularity
Depth of indefinite-cycle rotational irregu-
larity
Depth of overall rotational irregularity
Volume balance between the direct
sound (D) and the effect sound (W)
Output level
35: TAPE ECHO
A virtual tape echo that produces a realistic tape delay sound. This
simulates the tape echo section of a Roland RE-201 Space Echo.
fig.MFX35
L in
Direct Level
Tape Echo
R in
Direct Level
Parameter Value
S, M, L, S+M,
Mode #1 S+L, M+L,
S+M+L
Repeat Rate #2 0–127
Intensity #3 0–127
Bass -15– +15
Treble -15– +15
Head S Pan
Head M Pan L64–63R
Head L Pan
Tape Distortion 0–5
L out
Echo Level
Echo Level
R out
Description
Combination of playback heads to use
Select from three different heads with dif-
ferent delay times.
S: short M: middle L: long
Tape speed
Increasing this value will shorten the spac-
ing of the delayed sounds.
Amount of delay repeats
Boost/cut for the lower range of the echo
sound
Boost/cut for the upper range of the echo
sound
Independent panning for the short, mid-
dle, and long playback heads
Amount of tape-dependent distortion to
be added
This simulates the slight tonal changes that
can be detected by signal-analysis equip-
ment. Increasing this value will increase
the distortion.