Roland Music ATELIER AT500 Owner's Manual page 65

1.
The volume levels of each part are adjusted using the
corresponding [▲] and [▼] buttons.
Pressing the upper button ([▲] button) will increase the volume.
Pressing the lower button ([▼] button) will decrease the volume.
The volume can be set to any value from 0 to 12.
When the volume value shown in the display is 0, that part will produce no
sound.
You can also press the [▲] button or [▼] button of the part whose volume you
wish to adjust, so that the "Part Balance Monitor screen" is displayed for
several seconds, allowing you to check the volume balance.
fig.01-27.eps
Selecting and Playing Sounds
The Part Balance Monitor
screen is displayed for several
seconds and then closes
automatically.
If you touch <Hold>, the screen
continues to be displayed until
you touch <Exit>.
63