Roland Music ATELIER AT500 Owner's Manual page 59

Using the Harmonic Bar Settings of the Panel
If you've edited the harmonic bar settings in the screen, or if you've switched
Registrations so that the Vintage Organ settings have changed, you can
switch the Vintage Organ settings to the positions (settings) of the harmonic
bars on the panel (p. 53).
1.
Press the [H-Bar Manual] button.
When you press the Vintage Organ button, a vintage organ screen like the
following will appear.
Vintage Organ Screen
fig.01-24.eps
The screen will show the harmonic bars.
By touching the harmonic bars and sliding them, you can adjust the volume of
each footage. The volume can be adjusted over nine steps (0–8).
When a harmonic bar is pulled out all the way (8), the volume is loudest.
When it is pushed in all the way (0), there will be no sound.
Icon
Vib (Vibrato)
Cho (Chorus)
U/L/P
Hold
Description
Adds a vibrato effect to the sound.
Adds a chorus effect to the sound.
Touching cycles you through the available
< >
choices, which are: Upper Vintage screen, Lower Vintage
screen, and Pedal Vintage screen.
The Vintage Organ screen will automatically close after it has
been displayed for several seconds. If you touch <Hold>, the
screen will remain displayed until you touch <Hold> once again.
Selecting and Playing Sounds
When you touch the Vintage
Organ screen and then change
the settings, the screen is held
in that condition.
By touching the screen and
sliding your fingertip to the left
or right (horizontally), you can
adjust the volume of all
harmonic bars.
NOTE
It is not possible to apply both
vibrato and chorus
simultaneously.
57