Turning The Power On And Off; Turning On The Power; Turning Off The Power - Roland Music ATELIER AT500 Owner's Manual

Before You Start Playing

Turning the Power On and Off

941
Once the connections have been completed, turn on or off
power to your various devices in the order specified. By
turning on or off devices in the wrong order, you risk
NOTE
causing malfunction and/or damage to speakers and other
devices.

Turning On the Power

1.
Make sure of the following before the power is
turned on.
• Is the power cord correctly connected to the AC inlet?
• Is the power cord correctly connected to the AC outlet?
• Is the [Master Volume] slider (located at the left of the
Lower Keyboard) set to the Min (minimum) position?
fig.00-26.eps
2.
Press the [Power On] switch to turn on the
power.
fig. 00-27.eps, fig.00-27-3.eps
Lower position
The main screen will appear in the display.
942
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required before
NOTE
the unit will operate normally.
22
ON
Main Screen
3.
Adjust the volume to an appropriate level by
moving the [Master Volume] slider or
operating the expression pedal.
Now adjust the [Master Volume] slider to a suitable
level. The volume will be increased when the Expression
Pedal is pressed down, and decreased when the pedal
is returned.
fig.00-28.eps
increase
the volume
decrease
the volume

Turning Off the Power

1.
Before switching the power off, set the [Master
Volume] slider to the Min (minimum) position.
2.
Press the [Power On] switch to turn off the
power.
fig. 00-27.eps,fig.00-27-2.eps
Upper position
945
If you need to turn off the power completely, first turn off the
[Power On] switch, then unplug the power cord from the
NOTE
power outlet. Refer to "Power Supply" (p. 6).
decrease
the volume
increase
the volume
OFF