Wolf SO30U Design Manual page 77

W P S
O L F R O
Blower Considerations
Model L282212I comes with an
internal blower, all other hood liners
are shipped without the blower
assembly. Internal or remote blower
assemblies are available. The blower
assemblies are quite varied, and
depending on the amount of air you
want to move and the length of the
duct run, you have many options. A
straight, short duct run with a limited
number of elbows and transitions will
allow the ventilation hood to perform
most efficiently.
A remote mounted blower will
minimize the amount of blower
noise, but will not eliminate the noise
completely.
IMPORTANT NOTE: Install this hood
liner only with a Wolf blower.
Refer to the Pro Series ventilation
charts on pages 81-82 for recommen-
dations and blower options.
Ducting Considerations
IMPORTANT NOTE: All Wolf ventila-
tion products must be vented to the
outside. Use only metal ductwork.
Local building codes may require the
use of make-up air. Consult your local
HVAC professional for specific require-
ments in your area.
Wolf Pro Series hood liners have a
vertical discharge location as shown
in the illustration.
Dimensions in parentheses are in millimeters unless otherwise specified.
V
E R I E S E N T I L A T I O N
ROOF CAP OR REMOTE BLOWER
10" ROUND DUCT (ALL OTHER LINERS)
Ducting considerations Pro Series ventilation hood liners.
8" ROUND DUCT (L282212I)
SOFIT OR CABINET
OR DUCT COVER
DECORATIVE HOOD
12"
(305)
HEIGHT OF LINER
22
DEPTH OF LINER
30" 36"
TO
(762 - 914)
COOKING SURFACE
TO BOTTOM OF
DECORATIVE HOOD
37"
(940)
TO COOKING
SURFACE
VERTICAL DISCHARGE ONLY FOR VENTILATION HOOD LINERS.
*DIMENSIONS FOR TRANSITION INCLUDES FLANGES.
DUCTWORK INSTALLATION
THROUGH ROOF
17-3/4"W x 4-1/4"D TO 8" ROUND
9-3/8"H (L282212I)
22-1/4"W x 9"D TO 10" ROUND
10"H (ALL OTHER LINERS)
VERTICAL DISCHARGE
HOOD LINER
1
/ "
2 (572)
TRANSITION*
77