Honeywell SmartLine STT700 HART User Manual page 41

Device Setup/Basic
Configuration/Process
Values/PV [Loop]
Device Setup /Basic
Configuration/Process
Values/SV [Cold Jn.
Temperature]
Device Setup /Basic
Configuration/Process
Values/TV[Sensor 1]
Device Setup /Basic
Configuration/Process
Values/QV[Sensor 2]
Online/Device Setup/Basic
Configuration/
Process Values
Online Menu Flow
Basic Configuration / 4-20mA Outputs
Device Setup /Basic
Configuration/4-20mA
Outputs/PV Loop current
Revision 1
PV[Loop]
SV [Cold Jn.
Temperature]
TV [Sensor 1]
QV [Sensor 2]
PV Unit
PV Damp
SV Unit
Parameter menu/
name
PV Loop current
PV % rnge
PV LRV
PV URV
STT700 Series HART/DE Option User's Manual
Displays the current value of the Primary
Variable (loop PV according to the control
mode selected) in user selected engineering
units
Displays the current value of the Secondary
Variable (CJ temperature) in user selected
engineering units
Displays the sensor input 1 value
Displays the sensor input 2 value
Select one of the pre-programmed
engineering units. STT700 temperature
readings can be displayed in the following
engineering units:
o o o o
C, F, Kelvin, R, mV, Ohms
Enter a value for damping of the device
output. Entries may be any value from 0.00
to 102.00 seconds.
Select the desired unit for measurement of
the Secondary Variable (cold junction
temperature) Selections available are:
o o o
C, F, R, Kelvin.
Description/Valid values
Displays the current value of Analog Output
in mA
Displays the current value of transmitter
output in %
Displays the current value of the Lower
Range Value (input which represents 0%
output) in user selected engineering units.
This value may be configured to any value
within the range.
Displays the current value of the Upper
Range Value (input which represents 100%
output) in user selected engineering units.
This value may be configured to any value
within the range.
Page 41