DIS Digital Conference System
Set transmission mode
The Transmission Mode menu item (4A) is used
to select which signals will be distributed over the
channels. It is also possible to switch all channels
off (Standby).
4 Setup/4A Transmission
4A Transmission
ON
Options
Description
Standby
All channels are switched off, no
signals are distributed.
On
Normal transmission. Input
signals are distributed on the
channels as set in the Channel
Quality sub-menu (4D).
Aux to All
The signals on the Auxiliary
inputs are distributed on one
carrier to all channels.
Test
A different test tone is
distributed on each channel.
The frequency increases with
increasing channel number. For
stereo channels the tone for left
and right will also be different.
Slave
The radiator signal on the slave
input is looped-through to all
radiators.
Set number of channels
Via sub-menu item 4B the number of channels
that will be used can be set.
Note that the maximum number of channels
depends on the transmitter type (8 or 32
channels) and the chosen quality modes.
4 Setup/4B Nr. of Ch.
4A Nr. of Ch.
Manual:
08
Options
Description
Automatic: nn
The number of used channels is
set automatically to the
maximum possible number of
channels depending on
transmitter type and the
selected quality modes).
Channels "nn":
Manual:
nn
Set the number of used
channels (the maximum
number depends on the
transmitter type and the
selected quality modes).
Channels "nn":
An asterisk (*) is shown when the selected
number is not possible because it is higher than
the maximum number of channels.
29
User Manual
{1 ... 32}
{1 ... 32}