View Transmitter Status; View Fault Status - Shure DT 6008 User Manual

DIS Digital Conference System

View transmitter status

The first screen
information about the present status of the
transmitter. The screen shows the name of the
transmitter (1st line) and the present transmission
mode (2nd line). (See section 0 to change the
transmission mode).
Transmitter Status
DT 6008
10 Channels
Options Description
Name The first line shows the name of the
transmitter
changing).
Modes The second line shows the actual
transmission mode:
nn channels Audio signals are distributed on nn
channels.
Aux to All The signal on the Aux. inputs is
distributed on all channels.
nn Ch. Test The test signals are distributed on nn
channels.
Slave The transmitter operates in slave-
mode: the radiator signal on the slave
input is looped-through to all radiator
outputs
Standby The transmitter is in standby mode
(not transmitting).
Emergency Call An emergency signal from the Aux.
inputs is distributed to all channels.

View fault status

The fault status of the radiators can be seen in the
second screen of the Main menu:
of the Main menu
(see section
1 Fault Status
gives
1 Fault Status
No Faults
Options
No Faults
Radiator Fault
No Radiators
.
When the system detects a failure for the first
0 for
time, a flashing fault message pops-up on any
menu screen:
Radiator Fault
No Radiators
No Network
Network Error
Push the menu button to remove the fault
message from the screen and to go back to the
menu screen that was visible before the fault
message popped-up. The flashing message will
also disappear when the fault has been resolved.
27
Description
The connected radiators function
without problems.
One of the connected radiators is
not functioning properly.
No radiators are connected to
the transmitter.
or
or
or
User Manual