Digital Receivers; Description; Operation - Shure DT 6008 User Manual

DIS Digital Conference System

Digital Receivers

Description

The receivers are available for 4, 8 or 32 channels.
They can operate with a rechargeable NiMH
battery pack or with disposable batteries and have
controls for channel selection, volume adjustment
and an on/off push button. All receivers have a 3.5
mm (0.14 inch) stereo jack output socket for
mono or stereo headphones.
An LCD display shows the channel number and
indicators for signal reception and low battery
power.
Charging circuitry is included in the receiver.
Figure 0-A Receiver, front view and back view
1. Charging indicator LED - Used in combination
with the charging equipment.
2. Headphone connector - A 3.5 mm (0.14 inch)
stereo jack output socket for the headphone,
with integrated Stand-by/Off-switch.
3. LCD Display - A two digit display showing the
selected channel. An antenna symbol is visible
when the receiver picks up an infra-red signal of
adequate quality. A battery symbol is visible
when the battery pack or the batteries are
almost empty.
4. Volume control - A slider to adjust the volume.
5. Channel selector - An up/down switch to
select an audio channel. The channel number
is shown on the LCD display.
6. On/Off button - When a headphone is
connected, the receiver switches to Stand-by
state. Pressing the On/Off button switches
the receiver from Stand-by to On. To switch
back to Stand-by, press and hold the button
for approx. 2 seconds. When the headphone
is removed,
automatically to the Off-state.
7. Battery pack connector - This connection
is used to connect the battery pack to the
receiver. Charging is automatically disabled
when this connector is not used.
8. Charging contacts - Used in combination
with the charging equipment to recharge the
battery pack (if used).
9. Battery pack or disposable batteries -
Either a rechargeable BP 6001 NiMH battery
pack or two disposable AA-size 1.5 V
batteries.
Note: When the receiver is not used,
disconnect the headphones. This ensures that
the receiver is totally switched-of and no energy
is consumed from the batteries or the battery
pack.

Operation

The receiver cannot operate when no
headphone is connected. After connecting the
headphone the receiver switches to stand-by
mode. Push shortly on the on/off button to
switch the receiver on.
The channel number is shown on the LCD
display.
The channel can be changed with the channel
selector.
Push it to the up- or down-position to increase
or decrease the channel number. The highest
channel number is automatically matched to the
number of channels that has been set on the
transmitter (see section 0).
A battery symbol is visible on the display when
the batteries or the battery pack is almost
empty.
38
User Manual
the receiver switches