Dt 6008 & Dt 6032 Transmitters; Description - Shure DT 6008 User Manual

DIS Digital Conference System
DT 6008 & DT 6032 Transmitters

Description

The transmitter is the central element of the DCS
6000 Digital IR system. It accepts asymmetrical
audio sources from a maximum of 32 external
channels (dependent on the transmitter type) and
can be used with the DCS 6000 Digital Conference
System. It can also be used with analogue
discussion and interpretation systems (e.g. CIE
9000), or as a stand-alone system distributing
external audio sources.
The transmitter is suitable for either table-top or
19-inch rack-mounted use. Four feet (for table top
use) and two mounting
mounting) are supplied.
Figure 0-A Front view of DT 6008 and DT 6032 Transmitter
1. Mains on/off switch – After switching the
mains on, the transmitter starts up and the
display (3) will light-up.
2. Mini IR-radiator – Four IREDs, transmitting
the same infra-red signal as the radiator output.
This can be used for monitoring purposes. They
can be disabled via the configuration menu.
3. Menu display – A 2x16 character LCD-display
gives information about the transmitter status.
It is also used as a an interactive display for
configuring the system.
4. Menu button – A turn-and-push button to
operate the
combination with the display (3).
5. Monitoring headphone output – A 3.5 mm
(0.14 inch) jack socket to connect a headphone
for monitoring purposes. It can be disabled via
the configuration menu.
Note: The mini IR-radiator and the headphone
output can also be permanently disabled by
removing two resistors
brackets (for
configuration software
Figure 0-B
rack
Figure 0-C
1. Mains input – Euro mains socket. The
transmitter has automatic mains voltage
selection. A mains cable is provided.
2. Emergency switch connector – A
terminal
'normally open' switch. When the switch
is closed, the audio signal on the Aux right
input is distributed on all output channels,
overriding all other audio inputs.
3. Auxiliary audio inputs – Two female
XLR connectors for extra audio inputs.
They can be used to connect auxiliary
symmetrical audio signals such as a
music installation, the floor language or
emergency messages.
4. Audio signal inputs – 8 or 32 cinch
in
plugs to connect external asymmetrical
audio input signals. The number of
connectors depends on the transmitter
type.
5. Radiator signal loop-through input –
A HF BNC connector to loop-through the
radiator output of another transmitter.
6. Radiator signal outputs – Six HF BNC
connectors,
radiators. Up to 30 radiators can be loop-
through connected to each output. RG59
Cable must be used.
18
Back view of DT 6008 Transmitter
Back view of DT 6032 Transmitter
block socket
used to
User Manual
for a single,
connect the