Installation; Connections; Connecting The Dcs 6000 Conference System; Connecting Other Audio Sources - Shure DT 6008 User Manual

DIS Digital Conference System

Installation

The transmitter can be placed on a table or
installed in a standard 19" rack.
When installing in a 19" rack the supplied 19"
brackets shall be fixed to the front side of the
transmitter by unscrewing the crews holding the
top and button cover and then fix the brackets
using the same screws.

Connections

This chapter gives an overview of typical system
connections using the DT 60xx range transmitter:

Connecting the DCS 6000 Conference System

Connecting other external audio sources
Connecting an emergency signal switch
Connecting another transmitter
Connecting the DCS 6000 Conference
System
The transmitter is
Conference System directly to a CU 6105 or CU
6110 or to an AO 6004 or AO 6008 Audio Output
Unit. Each AO 6008 can feed up to 8 'Audio Signal
Inputs' in the transmitter.
Figure 0-A Connecting the DCS 6000 Conference System.
Please refer to the individual DCS 6000 user
manuals for more information.

Connecting other audio sources

The transmitter has
(depending on the transmitter type) to interface
with external asymmetrical audio sources, such as
connected to DCS
up to 32 audio inputs
congress systems from other manufacturers or
for music distribution.
The audio
connected to the audio input cinch connectors.
Figure 0-B

Connecting an emergency signal

To use the emergency signal function, a switch
(normally-open) must be connected to the
emergency switch connector. The reaction of the
transmitter on a closed switch depends on the
6000 configuration of the auxiliary inputs (see also
section 0):
If the auxiliary input is 'Mono + Emergency',
the audio signal on the Aux-Right input is
distributed to all output channels, overriding
all other audio inputs.
If the auxiliary input is 'Stereo' or 'Stereo to
Mono', the audio signals on the Aux-Left and
Aux-Right inputs are distributed to all output
channels, overriding all other audio inputs.
Figure 0-C
19
signals (stereo
Connecting external audio sources to the transmitter
Connecting an emergency signal
User Manual
or mono) are