Ricoh A251 Operating Instructions Manual page 92

9. Set Paper and RF
Select indicators
10. Clear Modes/Energy
Saver key
11. Program key
12. Function Select key
13. Plus and minus key
14. Leading Edge/Trailing
Edge/Copy Counter
indicator
15. Bypass Select/Roll
Paper Cut key
16. Copy Media key
17. Emergency Stop
key
18. Density indicator
Density keys
19. Clear/Stop key
The Set Paper indicator on the left lights when you select Bypass.
The RF Select indicator on the right lights when you select Roll
Paper.
Cancels all current settings. When you hold down
this key for three seconds or more, the copier enters
Energy Saver mode allowing you to conserve power.
To exit Energy Saver mode, press this key again.
Allows you to recall or set a program.
Press to change which setting you are editing. The current selec-
tion is shown by the indicators
above: Paper Length
Leading Edge
Trailing Edge
Copy Counter
Also use this key to copy a selected portion of an original.
Press to increase the setting being edited.
Press to decrease the value being edited.
Displays the margin settings and the number of copies
made.
Selects the paper feed type (when the Roll Feeder
option is installed). Also press to stop a copy job.
Press to select the type of copy paper you are using.
The copier will apply more or less heat accordingly.
Press to stop the copying process immediately.
Use if your original is getting stuck in the copier.
If you stop the operation by pressing this key, remove both the
original and paper.
Shows the density level the copies will have.
Press the left key to make copies lighter.
Press the right key to make copies darker.
While entering numbers, press to cancel a number to have entered.
While copying, press to stop copying.
After copying has finished, press this key, then remove the origi-
nal.
7