Ricoh A251 Operating Instructions Manual page 41

2 Slide the paper straight into the copier until it
stops, or press the RF Select key to turn on
the "RF Select " indicator.
3 Set the original.
4 Press the Function Select key when the lead-
ing edge of the area to be copied comes to the
position where it is covered with the original
table cover.
The "P" will stay on, not blinking.
The copier starts copying.
5 Press the Function Select key when the trail-
ing edge of the area to be copied comes to the
position where it is covered with the original
table cover.
The "P" will start blinking again.
6 After the paper has been delivered, hold down the Function Select key for three seconds to turn
the function off.
The "P" will disappear.
SB009
a
b
SB043
b
SB044
33