Server Board Installation; Tools And Supplies Needed; Before You Begin; Emissions Disclaimer - Intel SDS2 Product Manual

2 Server Board Installation

Tools and Supplies Needed

•
†
Phillips (cross head) screwdriver (#1 bit and #2 bit)
•
Flat blade screwdriver
•
Needle nosed pliers
•
Antistatic wrist strap and conductive foam pad (recommended)

Before You Begin

Emissions Disclaimer

To ensure EMC compliance with your local regional rules and regulations, the final configuration
of your end system product may require additional EMC compliance testing. For more information
please contact your local Intel Representative.
See "Regulatory and Integration Information" on page 85 for product Safety and EMC regulatory
compliance information. This is an FCC Class A device. Integration of it into a Class B chassis
does not result in a Class B device.

Safety Cautions

CAUTIONS
Electrostatic discharge (ESD) & ESD protection: ESD can damage disk
drives, boards, and other parts. We recommend that you perform all
procedures in this chapter only at an ESD workstation. If one is not
available, provide some ESD protection by wearing an antistatic wrist strap
attached to chassis groundany unpainted metal surfaceon your server
when handling parts.
ESD and handling boards: Always handle boards carefully. They can be
extremely sensitive to ESD. Hold boards only by their edges. After
removing a board from its protective wrapper or from the server, place the
board component side up on a grounded, static free surface. Use a
conductive foam pad if available but not the board wrapper. Do not slide
board over any surface.
15