Power Button Board - HP Stream x360 Maintenance And Service Manual

Power button board

NOTE: The power button board spare part kit does not include the power button board cable. See
button board cable on page 43
is available using spare part number 906777-001.
Description
Power button board
Before removing the power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the power button board:
1. Remove the four Phillips PM2.5×6.3 screws (1) that secure the display left hinge to the keyboard/
top cover.
2. Swing the display left hinge (2) up and back until the power button board is accessible.
3. Release the ZIF connector (1) to which the power button board cable is connected, and then disconnect
the power button board cable from the system board.
4. Detach the power button board cable (2) from the keyboard/top cover. (The power button board cable is
attached to the keyboard/top cover with double-sided adhesive.)
for connector board cable removal instructions. The power button board cable
Bottom cover on page 28).
Battery on page 30).
Component replacement procedures
Power
Spare part number
910162-001
45