Connector Board Cable - HP Stream x360 Maintenance And Service Manual

Connector board cable

Description
Connector board cable
Before removing the connector board cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the connector board cable:
1. Release the ZIF connector (1) to which the connector board cable is attached, and then disconnect
the connector board cable from the system board.
2. Release the ZIF connector (2) to which the connector board cable is attached, and then disconnect
the connector board cable from the connector board.
3. Remove the connector board cable (3).
Reverse this procedure to install the connector board cable.
Bottom cover on page
Battery on page 30).
28).
Component replacement procedures
Spare part number
906784-001
55