TouchPad cable
Description
TouchPad cable (includes double-sided adhesive)
Before removing the TouchPad cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the TouchPad cable:
1.
Release the ZIF connector (1) to which the TouchPad cable is attached, and then disconnect
the TouchPad cable from the system board.
2.
Release the ZIF connector (2) to which the TouchPad cable is attached, and then disconnect
the TouchPad cable from the TouchPad.
3.
Remove the TouchPad cable (3).
Reverse this procedure to install the TouchPad cable.
52
Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page
30).
28).
Spare part number
906781-001