Touchpad - HP Stream x360 Maintenance And Service Manual

TouchPad

NOTE: The TouchPad spare part kit includes the TouchPad bracket.
NOTE: The TouchPad spare part kit does not include the TouchPad cable. Refer to
on page 52 for TouchPad cable removal instructions. The TouchPad cable is available using spare part number
906781-001.
Description
TouchPad in aqua blue finish
TouchPad in jet black finish
TouchPad in snow white finish
TouchPad in violet purple finish
TouchPad in infinity purple finish
Before removing the TouchPad, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the TouchPad:
1. Release the ZIF connector (1) to which the TouchPad cable is attached, and then disconnect
the TouchPad cable from the system board.
2. Remove the three Phillips PM2.0×2.3 screws (2) that secure the TouchPad to the keyboard/top cover.
3. Remove the six Phillips PM2.0×3.3 screws (3) that secure the TouchPad and the TouchPad bracket to
the keyboard/top cover.
4. Remove the TouchPad bracket (4).
Bottom cover on page
Battery on page 30).
TouchPad cable
28).
Component replacement procedures
Spare part number
911119-001
911118-001
912835-001
906786-001
L21648-001
53