Take-Up Unit Does Not Operate; Problem In Network (Rip Does Not Recognize The Printer); Sheet Cutter Does Not Operate; Error Message - Roland VersaUV LEJ-640 Service Notes

6-10 TAKE-UP UNIT DOES NOT OPERATE

NO CHECKING POINT
The cable for Take-Up
1
Unit is not connected
AUTO switch is not
2
ON
Check the cable
3 connection/bad
contact
Life of the Take-up
Motor
4
Take-up Motor is
broken
Take-Up Board is
5
broken

6-11 PROBLEM IN NETWORK (RIP DOES NOT RECOGNIZE THE PRINTER)

NO CHECKING POINT
Turn off the main
1 power and restart the
printer
2 Refix the cable
3 Network problem
Main board is
4
damaged

6-12 SHEET CUTTER DOES NOT OPERATE

NO CHECKING POINT
Limit position is not
1
appropriate.

6-13 ERROR MESSAGE

NO CHECKING POINT
1 service call
2 Internal Error
ACTION
Connect the cable to
the printer
Make the setting for
the AUTO switch on
Check the cable
[3-16 TAKE-UP
connection/bad
BOARD
contact
REPLACEMENT]
Replace the cable
[3-16 TAKE-UP
Replace the Take-Up
BOARD
Board
REPLACEMENT]
ACTION
Connect them directly
with a crossover cable
Replace the Main
board
ACTION
[4-5 LIMIT POSITION
Perform Limit Position
& CUT DOWN
& Cut Down Position
POSITION
Initialize
INITIALIZE]
[4-15 MEDIA
Correct the fixation of THICKNESS
the Sheet Cutter Unit CHECKING SENSOR
ADJUSTMENT]
ACTION
Restart the printer
Refer to SERVICE
[6-14 SERVICE CALL]
CALL below
Restart the printer
Upgrade the firmware
to the latest version
REFERENCE
Check the connection/bad contact of the cables from AC
Junction Board to SW Power Unit, DC Junction Board,
Head Board, Main Board, TU Junction Board and Take-Up
Board. Replace the cable if there is a problem in the cable
itself.
REFERENCE
It can be solved by restarting the printer with the main
power. Try it several times.
It can be solved by refixing the network cable. Try it
several times.
The problem may be in the network when they are
connected through LAN. It can be identified whether the
problem is on the printer or the network, by connecting the
PC and the printer directly with a crossover cable.
Main board may be damaged if the problem is not solved
by the measures above.
REFERENCE
When the Limit Position is not correctly set, it causes a
cutter-down error when separating the sheet.
If the Sheet Cutter Unit is tilted, the bush might not be
pushed all the way to the end. In case the bush position is
not correct, re-fix the Sheet Cutter Unit correctly.
REFERENCE
Restart the printer and see if the same error occurs again.
Never install the printer in a location where it is tilted or
where it may wobble or experience vibration.
Check the revision record of the firmware version and
upgrade it if the error has been solved in the firmware.
6-7
OUTLINE
OUTLINE
OUTLINE
OUTLINE