Limitations Of Route Policy Map - Cisco CRS Series Configuration Manual

Implementing Multicast Routing on Cisco IOS XR Software
Command or Action
Example:
RP/0/RP0/CPU0:router(config-ldp-mldp-af)# end
Step 6
commit
Step 7 Use the show command to verify the configuration: show
running-config mpls ldp mldp
An example output showing the mLDP make-before-break output
RP/0/1/CPU0:GSR3#sh mpls mldp database opaquetype ipv4
mLDP database
LSM-ID: 0x00019
FEC Root
Opaque decoded
Features
Upstream neighbor(s) :
Downstream

Limitations of Route Policy Map

Limitations:
The following are the limitations of the route policy map:
• After changing the Route Policy filter to be more restrictive, the mLDP label bindings that were earlier
Type: P2MP
: 10.0.0.1
: [ipv4 0.0.0.0 224.1.1.1]
: MoFRR MBB RFEC
10.0.0.1:0 [Active]
Next Hop : 10.0.3.3
Interface : GigabitEthernet0/2/1/1
Local Label (D) : 16028
client(s):
LDP 10.0.0.2:0 Uptime: 03:25:15
Next Hop : 10.0.4.2
Interface : GigabitEthernet0/2/1/2
Remote label (D) : 16029
allowed are not removed. You have to run the clear mpls ldp neighbor command to clear the mLDP
database.
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
Multipoint Label Distribution Protocol Route Policy Map
Purpose
An example output is as shown:
Wed Jun 25 13:05:31.303 IST
mpls ldp
mldp
address-family ipv4
make-before-break delay 0
make-before-break route-policy mldp_policy
mofrr route-policy mldp_policy
neighbor route-policy mldp_policy out
neighbor 1.1.1.1 route-policy mldp_policy
in
neighbor 1.1.1.1 route-policy mldp_policy
out
neighbor 2.2.2.2 route-policy mldp_policy
out
recursive-fec route-policy rfec
!
!
!
Uptime: 03:25:15
Uptime: 03:25:15
59