Implementing Multicast Routing on Cisco IOS XR Software
Command or Action
Step 8
show pim [ipv4 | ipv6] group-map [ip-address-name]
[info-source]
Example:
RP/0/RP0/CPU0:router# show pim ipv4 group-map
Step 9
show pim [vrf vrf-name] [ipv4 | ipv6] topology
[source-ip-address [group-ip-address] | entry-flag
flag | interface-flag | summary] [route-count]
Example:
RP/0/RP0/CPU0:router# show pim topology
Configuring Native PIM BIDIR
Perform these steps to configure native PIM BIDIR.
SUMMARY STEPS
1. configure
2. ipv4 access-list name
3. [sequence-number] permit source [source-wildcard]
4. interface type interface-path-id
5. {ipv4 | ipv6} address address mask
6. router ospf 100
7. nsf cisco
8. area area_id
9. interface type interface-path-id
10. multicast-routing [address-family {ipv4 | ipv6}]
11. nsf
12. rate-per-route
13. interface all enable
14. router pim [address-family {ipv4 | ipv6}]
15. rp-address ip-address [group-access-list] [bidir]
16. commit
Purpose
(Optional) Displays group-to-PIM mode mapping.
(Optional) Displays PIM topology table information for a
specific group or all groups.
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
Configuring Native PIM BIDIR
71