Configuring A Route-Policy Definition - Cisco CRS Configuration Manual

Configuring a Route-Policy Definition

Example:
RP/0/RP0/CPU0:router(config-vrf-af)# exit
Exits interface configuration mode.
Step 7 address-family ipv6 unicast
Example:
RP/0/RP0/CPU0:router(config-vrf)# address-family ipv4 unicast
Specifies an IPv4 address-family address.
Step 8 import route-target [0-65535.0-65535:0-65535 | as-number:nn | ip-address:nn]
Example:
RP/0/RP0/CPU0:router(config-vrf-af)# import route-target 500:99
Configures a VPN routing and forwarding (VRF) import route-target extended community.
Step 9 export route-target [0-65535.0-65535:0-65535 | as-number:nn | ip-address:nn]
Example:
RP/0/RP0/CPU0:router(config-vrf-af)# import route-target 700:88
Configures a VPN routing and forwarding (VRF) export route-target extended community.
Step 10 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring a Route-Policy Definition
Perform this task to configure a route-policy definition for CE-PE EBGP.
SUMMARY STEPS
1. configure
2. route-policy name pass
3. end policy
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
42
Implementing MPLS VPNs over IP Tunnels