Msdp-Vrf: Example; Configuring Route Policy For Static Rpf: Example; Configuring Ipv4 Multicast Vpn: Example - Cisco CRS Series Configuration Manual

Implementing Multicast Routing on Cisco IOS XR Software
ipv4 access-list 112
10 deny any 226.0.0.0 0.255.255.255
30 permit any any
!
router msdp
connect-source loopback 0
sa-filter in rp-list 111
sa-filter out rp-list 111
peer 172.16.0.1
!
peer 172.16.0.2
sa-filter out list 112
!
peer 172.17.0.1
!
peer 192.168.12.2
connect-source pos 0/2/0/0
!

MSDP-VRF: Example

This is an example where, peer 1.1.1.1 is configured in the VRF context for vrf1.
config
router msdp
vrf vrf1
exit
end
!
•

Configuring Route Policy for Static RPF: Example

router static
address-family ipv4 multicast
202.93.192.74 /32 202.40.148.11
!
route-policy pim-policy
set rpf-topology ipv4 multicast topology default
end-policy
!
router pim
address-family ipv4
rpf topology route-policy pim-policy

Configuring IPv4 Multicast VPN: Example

Cisco CRS Routers support only IPv4 addressing.
peer 1.1.1.1
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
MSDP-VRF: Example
139