Configuring Core Tree Protocol - Cisco CRS Series Configuration Manual

P2MP configurations at egress node and bud node
Command or Action
Step 4
static-rpf address range prefix
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)#
static-rpf 10.1.1.1 32
Step 5
mpls address
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)# mpls
10.2.2.2
Step 6 commit

Configuring Core Tree Protocol

SUMMARY STEPS
1. configure
2. multicast-routing
3. address-family {ipv4 | ipv6}
4. core-tree-protocol rsvp-te group-list name
5. commit
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 multicast-routing
Example:
RP/0/RP0/CPU0:router(config)# multicast-routing
Step 3 address-family {ipv4 | ipv6}
Example:
RP/0/RP0/CPU0:router(config-mcast)# address-family ipv4
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
134
Implementing Multicast Routing on Cisco IOS XR Software
Purpose
Enter the source and prefix length.
Enter the source PE address of the MPLS
P2MP tunnel.
Purpose
Enters multicast routing configuration mode.
Enters ipv4 (or ipv6)address-family submode.