Configuring Route Policy For Static Rpf - Cisco CRS Series Configuration Manual

Configuring Route Policy for Static RPF

Configuring Route Policy for Static RPF
SUMMARY STEPS
1. configure
2. router static
3. address-family[ipv4 | ipv6][ multicast |unicast]destination prefix interface-typeinterface-path-id
4. exit
5. route-policypolicy-name
6. set rpf-topology policy-nameaddress-family[ipv4 |ipv6]multicast | unicasttopologyname
7. end route-policy
8. router pim address-family[ipv4 |ipv6]
9. rpf topology route-policypolicy-namepim policy
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 router static
Example:
RP/0/RP0/CPU0:router(config) # router static
Step 3 address-family[ipv4 | ipv6][ multicast |unicast]destination prefix
interface-typeinterface-path-id
Example:
RP/0/RP0/CPU0:router(config-static) # address-family
ipv4 multicast 202.93.100.4/ 32 202.95.1.1
Step 4 exit
Example:
RP/0/RP0/CPU0:router(config-ipv4-afi) # exit
Step 5
route-policypolicy-name
Example:
RP/0/RP0/CPU0:router(config) # route-policy r1
Step 6 set rpf-topology policy-nameaddress-family[ipv4 |ipv6]multicast
| unicasttopologyname
Example:
RP/0/RP0/CPU0:router(config-rpl) # set rpf-topology p1
ipv4 multicast topology t1
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
130
Implementing Multicast Routing on Cisco IOS XR Software
Purpose
Enables a static routing process.
Configures the ipv4 multicast address-family
topology with a destination prefix.
Exits from the address family configuration
mode.
Configures the route policy to select the RPF
topology.
Configures the PIM rpf-topology attributes for
the selected multicast address-family.